How To Keep Winch Cable From Binding

Disclaimer: We may earn a small commission from sponsored links in this article at no additional cost to you.

Last Updated on May 29, 2022

Winches are a hauling or lifting device that uses a wire, chain, or even rope to wind parallel to the ground around with a drum while being ramped by hand or the motor. Winch recovery may be used to winch animal or human survivors up a hill, among other things.

However, even winches can also have issues, such as bounded winch cables.

You’ll start noticing that the winch cable seems to have become stuck or jammed at a certain point. 

Steps to Prevent Winch Cable Binding

Step 1:

Unspool here the winch cable towards the end manually. Hold the unrestricted end of the wire in one hand and hold the cable close to the fairlead with the other. 

Pull the winch cable down very hard as you can with your body weight and pull on just the winch cable while shortly pressing the out button just on the winch. Then, the winch cable will be released from the winch.

Step 2:

Attempt to do so without having to open the winch. You must secure the winch cable to either a fixed object or tree. 

You must gradually back up the vehicle while spooling out all the winch at the same time to produce tension within the cable, and you would not be establishing the winch for the unrestricted pool. 

If you back up your car too quickly, the gears within the winch might well be damaged. Because the winch’s job is to pull, it should not be pulled.

Step 3:

When too much cable is packed solely on a single side of a winch, it should not be greased. This could have occurred if you were winching at an angle with the winch. 

Use a lubricant that contains few corrosives or acids and ensure that all excess oil is removed.

Step 4:

Establish the winch cable to free spool and try to reverse your car. Parking the car immediately in front of the fixed object is recommended. Ascertain that the spool spins freely. 

If the spool does not do so, the problem is with the free spool knob rather than the cable, and the free end of the cable should be secured to something solid at ground level. 

If you think the free end of the winch cable is too short, use a strap, then slowly reverse the car, whereas the winch seems to be in a free spool.

How Can You Avoid Winch Cable Stuck?

You must first ensure that the cable has been wrapped under load, so if the cable seems loose and tension is applied, the cable may become stuck. 

This occurs when the cable’s free ends slip down and the cable’s position shifts. 

After that, you should re-spool the cable properly after each use to avoid the winch cable binding the next time you are using it. 

Then you could also set up a Spring-loaded Roller Fairlead as when the winch cable is spooled back onto the drum, and it is put under constant tension. Finally, consider replacing the kinked cable after that.

The Summary

A winch is a fantastic tool that comes in handy on off-road adventures, factory jobs, and sometimes even daily tasks that require moving heavy loads. 

Regrettably, even though a winch is designed to be a massive piece of equipment, it is not impervious to damage from the rough treatment it receives, so it may become jammed or stuck, which you can always fix.

Frequently Asked Questions

Is it necessary to oil my winch cable?

Rust and corrosion may have weakened the cable’s inner core, which is why it’s critical to use a specialized winch cable lubricant that protects the cable.

How many wraps can a winch have?

Wrap the cable at least eight times around the winch drum. The cable may come loose from the drum if you don’t, liberating the tension abruptly. Sudden shifts in the load that consequence could perhaps result in serious injury or death.

What is the purpose of a winch cable tensioner?

Heavy-duty coil springs are used to keep the winch cable tensioned.

About the Author: Brian Silvestro

Brian Silvestro is the founder and chief editor of OffroadersArena. He spends his free time tending to his BMW iX SUV and explaining its merits to anyone who'll listen.

Leave a Comment